Thingiverse
Nema 17 Holder for 30x30 by schmitty_creat
by Thingiverse
Last crawled date: 4 years ago
This is a holder for the stepper motor Nema 17, any size. You can screw on the Bosch profile 30x30 ore 30x60.
You need:
-Filament
-3d Printer :)
-4x aluprofile 30 Nut 8 M6
-4x M6x10 or 11 screw
For the mounting:
Don`t scare when you see thet the Nut dosent get into the Nut into the profile.
First you screw a M6 on a corner and fix it ( You can see the process at the image 10 to the end of the picture). After you shake the part a littel bit and than you screw the M6, a cross, on. Than you shake it so long that the part fits into (When it dosent get into you screw up harder).
Then you can screw the other two M6 on.
Only after the mounting on the profile you srew the Nema 17 on the holder!!!!!!
Hopefully someone can use this part.
You need:
-Filament
-3d Printer :)
-4x aluprofile 30 Nut 8 M6
-4x M6x10 or 11 screw
For the mounting:
Don`t scare when you see thet the Nut dosent get into the Nut into the profile.
First you screw a M6 on a corner and fix it ( You can see the process at the image 10 to the end of the picture). After you shake the part a littel bit and than you screw the M6, a cross, on. Than you shake it so long that the part fits into (When it dosent get into you screw up harder).
Then you can screw the other two M6 on.
Only after the mounting on the profile you srew the Nema 17 on the holder!!!!!!
Hopefully someone can use this part.