Natural breasts for Victoria 4

Natural breasts aim is to enhance Victoria 4 breasts control by adding a completely new set of morphs with the purpose of bringing better and more realism to Victoria 4 and fix varies issues.



New system

Natural breasts for V4 uses a single base breast size with 3 separated groups of morphs each designed to be used for a specific size. These are named “Small”, “Medium” and “Large”.



The reason for this is to take size and weight into account. This doesn’t mean that morphs from other groups might not be better suited in certain situations.



Important

Natural breasts for Victoria 4 is not meant to replace the normal Victoria 4 morphs but to be used as a supplement. And will also work with the standard Victoria 4 morphs.



------------------------------------------------------------------------------------------------------



Getting started



Step 1 - Prepare Victoria 4

Should you choose to use the Natural breasts base size morph its advised to set the following morphs for Victoria 4 to there lowest value:



“BreastSize” = -1.0

“BreastLarge” = -0.2



Step 2 - Add morphs

The morphs can be Injected by loading the file found in the category:



Poses - 3D-Mobster - Natural breasts for V4



Step 3 - Deciding breast size



Small: 0.0 to 0.4

Medium: 0.4 to 0.7

Large: 0.7 to 1.0



You are now ready to use the morphs.



------------------------------------------------------------------------------------------------------



Using conforming cloth

Since conforming cloth doesn’t have these morphs included you can copy them from Victoria 4 to the cloth in the following way:



Important:

Make sure that all morphs are at 0 before doing this or you might have to copy them again to get the cloth to adjust to the cloth.



1. Go to the menu Figure -> Copy Morphs From.. and choose Victoria 4

2. In the list choose all morphs which are named (Base size) / (Small).. / (Medium.. / (Large).. and click the Ok button.

3. Choose your cloth and make sure you have the “body” selected. Go to Properties for the Cloth (Tab next to parameters). Under the section called “When conforming:” check all checkboxes. You cloth now follows the morphs.



Last information

As with any morphs you can mix and match them as you see fit and nothing wrong in using morphs from the other categories if they give you better results.