Thingiverse
Nano hydropower plant, for survival an camper by CuervoRC
by Thingiverse
Last crawled date: 4 years, 3 months ago
Very powerful, it does not need much water current.
I will make a wind turbine and a crank to be able to put also in the generator module.
Material you need:
1x 5mm steel bar or threaded bar. 50mm long
2x bearings 16mm outer diameter, 5mm inner diameter, 5mm thickness
2x 1mm wire or 1mm nail (Is used as a pin between the shaft and the large gear wheel)
1x AC 3 Phase Micro Brushless Generator 3-24V (4€ on ebay )
1x 5mm steel rope 120cm
The steel rope to the turbine and connector is attached with two-component epoxy adhesive.
is based on this turbine: www.youtube.com/watch?v=iNuZaaJZd3w&list=FLpbNG1kAJ3rVOZ7e8484KWQ&index=1&t=31s
I will make a wind turbine and a crank to be able to put also in the generator module.
Material you need:
1x 5mm steel bar or threaded bar. 50mm long
2x bearings 16mm outer diameter, 5mm inner diameter, 5mm thickness
2x 1mm wire or 1mm nail (Is used as a pin between the shaft and the large gear wheel)
1x AC 3 Phase Micro Brushless Generator 3-24V (4€ on ebay )
1x 5mm steel rope 120cm
The steel rope to the turbine and connector is attached with two-component epoxy adhesive.
is based on this turbine: www.youtube.com/watch?v=iNuZaaJZd3w&list=FLpbNG1kAJ3rVOZ7e8484KWQ&index=1&t=31s