MyFlyDream AAT quick release plate by iPeel

Last crawled date: 3 years ago

This is a plate which locks over the MyFlyDream AAT tilt mechanism to allow quick release of the antenna for swapping with another.
The plate locks in place using a latch which clips over the bar at the bottom of the AAT tilt mechanism, on my print this was snug and had very little play, the latch was strong enough that I couldn't pull the plate away without triggering the latch to release.
The plate is printed in two parts to avoid any nightmare with support material and is assembled using two 3mm pan head M3 bolts and a couple of M3 nuts.
There are three sizes of the front plate (sticks to the back of whatever you are attaching to the AAT front), one of a minimal height, for when you want to stick the RX to the back of the antenna, a larger and much larger plate for when you want to stick the RX to the plate and not the antenna.