Thingiverse
My Pocket PI PC, V2.0, Preliminary by phiatt
by Thingiverse
Last crawled date: 4 years, 7 months ago
UPDATE: I have abandoned this project for the time being. With the advent of the Pocket
CHIP, I no longer have a purpose for my Pocket PC. I may pick it up again later.
After a long hiatus from 3D printing (6 months); last week I decided to get my printer back together. After a Radds + Arduino Due and a MS all metal hot end upgrades; I got back to work on an incomplete project. My version of the Raspberry Pi Pocket PC.
(Previous Version: http://www.thingiverse.com/thing:1739092 )
The new version has much the same hardware, the basic differences are, a better battery (4000 mAh), thinner design, slightly longer and wider, but ~14 mm thinner.
This is only preliminary, there are still a few things I need to change; thinner shorter HDMI cable, incorporate a slide switch to disconnect the Pi from the DC-DC converter, and move some holes around, that's about it
CHIP, I no longer have a purpose for my Pocket PC. I may pick it up again later.
After a long hiatus from 3D printing (6 months); last week I decided to get my printer back together. After a Radds + Arduino Due and a MS all metal hot end upgrades; I got back to work on an incomplete project. My version of the Raspberry Pi Pocket PC.
(Previous Version: http://www.thingiverse.com/thing:1739092 )
The new version has much the same hardware, the basic differences are, a better battery (4000 mAh), thinner design, slightly longer and wider, but ~14 mm thinner.
This is only preliminary, there are still a few things I need to change; thinner shorter HDMI cable, incorporate a slide switch to disconnect the Pi from the DC-DC converter, and move some holes around, that's about it