MPSM V2 switched display and encoder by Willybecher

Last crawled date: 4 years, 5 months ago

If you also mind that the rotary knob is under the bed, you should invest half an hour of your time ...
Tools:
Phillips
Allen key 2
Blade & torch alternatively small saw
Soldering iron and some wire
Chisel or alternative, mpCNC works too
Unscrew the bottom, 6 screws cross
Remove the connector from the display
Remove 4 Allen keys on the front
At the rotary encoder 4 cross out
Carefully pull off the rotary encoder, tighten the rotary knob
Loosen 2 more crosses, take out the inner shell knob
Carefully lift off the front with the spatula supplied, double-sided in the middle above / below, the rear part is also attached with double-sided, careful not to let anything break.
6 mm inside for signs see pictures and remove with a chisel for the display inside on the front panel
Use the blade and burner to make space on the holder for the cables
Assemble in reverse order after the cable from the encoder has been extended by at least 4cm ...
Have fun recreating it.
Attention, there are housings that have no recess