Thingiverse

M&P 2.0 Magazine Base Plate
by Thingiverse
Last crawled date: 5 years, 3 months ago
Base Plate for a M&P 2.0 Magazine.
Infill 90-100 %
Support - Yes
Print with layers going up/down. For reference a magazine has a bottom and a top. Have your layers print from bottom/top. Look at the Picture of the part on my slicing software for help!
PLA
Layer Res: 0.2 mm
Nozzle: 0.4 mm
Note: I fully loaded the magazine with 17 rounds and dropped it on a tile floor. The base plate did not break off. I did not try repeated drops, but as long as your not slamming fully loaded mags against concrete they should hold up just fine!
Infill 90-100 %
Support - Yes
Print with layers going up/down. For reference a magazine has a bottom and a top. Have your layers print from bottom/top. Look at the Picture of the part on my slicing software for help!
PLA
Layer Res: 0.2 mm
Nozzle: 0.4 mm
Note: I fully loaded the magazine with 17 rounds and dropped it on a tile floor. The base plate did not break off. I did not try repeated drops, but as long as your not slamming fully loaded mags against concrete they should hold up just fine!