M&P 15 AR style front shield and pistol grip by dave_root 3d model
Warning. This content is not moderated and could be offensive.
weapons
3dmdb logo
Thingiverse
M&P 15 AR style front shield and pistol grip by dave_root

M&P 15 AR style front shield and pistol grip by dave_root

by Thingiverse
Last crawled date: 3 years, 1 month ago
A remix of some other front grips and shields for an M&P15 style AR 15, I split the shields so they would print better on my machine. If you print the combination pistol grip and front shield, you will just need one of the front grips. These were about 1mm too long and needed to be trimmed on the forward end to fit my rifle... you may or may not find this to be the case for your use.... also, the pistol grip is a remix of another great job I found here on Thingiverse... I removed the side rails and sunk it into the front shield because the rails were too loose... the original was very well done and I basically just chopped the rails off... so some sanding and filing may be needed to clean things up...should not be more than most prints need... but I am not done printing it yet... I will update if it turns out too bad..thanks
12/31/2017...
I finished my print... fits well... not much file work needed...I did have to shorten the muzzle end by a mm or so... just as I did for the other half

Tags