Thingiverse
Motorhome tap nozzle by spyrosm
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a replacement for the Samba tap nozzle usually found in motorhomes and caravans.
Print it, get the O-ring from the original one and put it on the 3d print.
No supports are normally needed.
The model contains numerous hole-guides on the water output side. I chose not to model them right-through as my printer is not very good at small holes. Drill through using a 1mm drill.
The part is push-fit on the Samba tap, as is the original. There is an orifice on the side that helps getting out the original with a flat head screwdriver.
Print it, get the O-ring from the original one and put it on the 3d print.
No supports are normally needed.
The model contains numerous hole-guides on the water output side. I chose not to model them right-through as my printer is not very good at small holes. Drill through using a 1mm drill.
The part is push-fit on the Samba tap, as is the original. There is an orifice on the side that helps getting out the original with a flat head screwdriver.