mostly printed touch plate, Tastplatte, XYZ-Probe by AxlNam

Last crawled date: 3 years ago

nothing special but I had designed my own 3d model thats more print friendly.
I don't want to cut or buy a touch plate from the market.
To get it to work I had coated it with aluminium foil or kitchen foil with a simple glue
see picture.
Use a straight ground to press the plate on the foil. Don't touch the foil
and lay it on the table and press always the plate on the foil!!!
glue the plate not the foil.
It works perfect!!!
ensure your prints are accurate (I used an Anycubic i3 mega)
measure with a 90 degree precision steel (Haarwinkel)
use a very fine sand paper to make a finish and clean it (only to remove burr or flash)
make a coating like you want but ensure electrical connection
there is a hole for a M3 screw
finish your wiring and ensure connection to Estlcam
Use a digital caliper or other suitable measurement tool and measure the accurate dimension
and type in Estlcam
printing it with a high infill more the 50% to get more weight