Thingiverse
Modules with better alignment and lips for netpot
by Thingiverse
Last crawled date: 5 years, 4 months ago
First of all all credits to Archipelagourbanfarms, with his desing.(https://www.thingiverse.com/thing:2403922)
I liked this desing soo much (and i printed it ofc). But i'm a damn perfectionist and seeing that the top was slightly off center with a step, it was bothering me.
So, i redesigned the module adding from 1 to 3 slots, even with a lip to hold the net cup once the plant/s is/are quite big (as seen here: https://www.thingiverse.com/make:450646).
Note: if you plan to print the modules with the lips, you should print them upside down, just to avoid any support.
hope you like them, good luck!
I liked this desing soo much (and i printed it ofc). But i'm a damn perfectionist and seeing that the top was slightly off center with a step, it was bothering me.
So, i redesigned the module adding from 1 to 3 slots, even with a lip to hold the net cup once the plant/s is/are quite big (as seen here: https://www.thingiverse.com/make:450646).
Note: if you plan to print the modules with the lips, you should print them upside down, just to avoid any support.
hope you like them, good luck!