Modular Mounting System Tablet Clamp (extended 40mm) with Tab by jerwil

Last crawled date: 3 years, 1 month ago

Update 1/10/2020: This thing is most likely no longer compatible with the current modular mounting system clamp, as it has been redesigned and replaced on their page since this part was designed. This thing is here for reference and for those with the older design that can benefit from it. I hope to make a similar design for the new modular mounting system clamp in the near future.
This is a (further) extended version of the top portion of the phone clamp from the excellent modular mounting system. I added a total of 40mm to the original design. I modified this to fit my nexus 7 (2nd gen) into the clamp. By swapping out this part for the original "Phone_clamp_up_WITH_tab", it can accommodate tablets from approximately 3-3/4" to 4-3/4" wide using the original bolt and lower clamp.
If you want to make an even longer version, you can edit the OnShape part and simply modify the extrude properties on the "Clamp Up" file.
I was inspired by this remake, but I needed the clamp to be even longer to fit my tablet.
In the photos the clamp is shown attached to the Xbox 360 Controller Phone Clip with Modular Mounting System that I remixed.