Model Aircraft Stand by Mxfox

Last crawled date: 2 years, 11 months ago

This is a swept stand for a flying model aircraft.
Print settings:
1mm to 0.06mm layer height (Depending on printer)
Full supports are needed
Set higher bed temperature (If applicable) to avoid edge warping (~60C)
The aircraft designed for this stand was a 1:48 scale Kitty Hawk F-101B but will fit other planes with creativity.
The stand was attached with a hole drilled at the bottom, it is recommended to use hot glue to attach as other polymer cements can take some time to set.
The base of the model has a 60mm x 80mm rectangular indent for a letter size information card.