MK8 Extruder Wire Loom Cable Clip For Ender-3 by Namemogan

Last crawled date: 3 years, 1 month ago

I use this clip with the Bullseye duct horizontal wire management style (the cable management channel on the Bullseye / and Petsfang pulls the loom in a horizontal direction).
The built in Ender 3 extruder clip doesn't hold the wire tight enough and doesn't provide a lot of horizontal stability. This clip has a small horizontal platform and holes for cable ties that will hold the cable horizontally. I used a m3 x 12 screw, but the ender factory screw is just long enough to use. The hole might be a little tight, run the screw through it first to make it easier to install.
Print with 'support to bed only'. I used 100% infill due to the small size, but you could probably go less. The sample shown was printed in the orientation shown in the preview.