Thingiverse
MJX600 chassis by StringyMcStringface
by Thingiverse
Last crawled date: 4 years, 2 months ago
Designed this on Tinkercad.
Bear in mind that I'm not an expert.
You may want to reduce the pin size to 0.95 or so in your slicer, so they fit better depending on your printer accuracy. When the pins are fitted, cut them down accordingly.
It is a strong frame, but please redesign if you want, ie so its lighter etc. Its fairly modular.
The camera holder and stand is optional to reduce weight.
I have used the drone pcb sponge washers under the pcb and put a touch of sealant on top of the pcb guide pins.
I secured the motors onto the arms with a glue gun. The wires run in the arm centre.
Flight is very stable. Could do with being more aerodynamic though in case its windy.
Any questions welcome.
Bear in mind that I'm not an expert.
You may want to reduce the pin size to 0.95 or so in your slicer, so they fit better depending on your printer accuracy. When the pins are fitted, cut them down accordingly.
It is a strong frame, but please redesign if you want, ie so its lighter etc. Its fairly modular.
The camera holder and stand is optional to reduce weight.
I have used the drone pcb sponge washers under the pcb and put a touch of sealant on top of the pcb guide pins.
I secured the motors onto the arms with a glue gun. The wires run in the arm centre.
Flight is very stable. Could do with being more aerodynamic though in case its windy.
Any questions welcome.