MiSTer Sidecar USB case add-on v1.1 for MiSTer - Case Universal by NegSol

Last crawled date: 3 years, 2 months ago

MiSTer Sidecar USB case add-on usable with MiSTer USB Hub v1.1 daughter board
Sidecar will with MiSTer - Case Universal v5.2
and
Sidecar will with MiSTer - Case Universal v1.2 :)
Four 2.5-3 mm screws are needed to more firmly attach the front and rear panel. Both panels act as brackets and will hold on to the MiSTer Case. (If you do not like the additional holes print the no_holes version of the shell.)
For assembly make sure to only slide the panels fully in after you attached them to the MiSTer case. You can also try sliding one panel in (all the way) and then try to attach the case will sliding in the remaining panel in an angle. Take your time and do not force it.
Panels: Make sure to orient the panels flat on your print bed and use supports for these panels! Print height should be between 0.18 to 0.2mm.
Shell: The shell should print without supports. Print height should be between 0.18 to 0.2mm.
For more info:
https://github.com/MiSTer-devel/Main_MiSTer/wiki
http://www.atari-forum.com/viewtopic.php?f=117&t=34098
--
Also available on shapeways:
https://www.shapeways.com/shops/negsol-design