Thingiverse
Minimal Design extruder (3Dator inspired w/ spring) by jvamps
by Thingiverse
Last crawled date: 4 years, 5 months ago
I really liked how the guide was for the filament but was really confused on the tension needed for it and usually slipped half way through my prints. So! decided to try a different spin on it.
everything done with no supports, but the tension bolt..hole? may need to be dremeled a bit as well as the spring retainer center.
fairly straight forward design. I used an m6-40mm nut/bolt, but can use any size if needed. I wanted this easy to install. mainly just look at the top-view pic to get the idea.
Print all but "complete.stl." that's only the Mach up
Updates:
non so far
everything done with no supports, but the tension bolt..hole? may need to be dremeled a bit as well as the spring retainer center.
fairly straight forward design. I used an m6-40mm nut/bolt, but can use any size if needed. I wanted this easy to install. mainly just look at the top-view pic to get the idea.
Print all but "complete.stl." that's only the Mach up
Updates:
non so far