Thingiverse

Miniature Filament Spool Props by agepbiz
by Thingiverse
Last crawled date: 4 years, 4 months ago
3D printed miniature filament spools. This is just a small project I did in between bigger projects. They ended up a bit cute and colorful so I decided to share them. This is a mix between high and low resolution FDM printing. I achieved the filament look by printing the filament at 0,4mm layer height, the spools themselves where done using best possible resolution. The spools are snap fit, but since I did not calibrate the printer profile between filament colors I used a dab of glue on few of them. This was an experiment too see how small I was able to make them, these are too small to work as keychain
Subscribe or follow me on:
Instagram:
www.instagram.com/agepbiz
YouTube:
www.youtube.com/user/agepbiz
Twitter:
www.twitter.com/agepbiz
Best regards
Stian
WARNING: CHOKING HAZARD - Small parts
Not for children under 3 yrs.
Subscribe or follow me on:
Instagram:
www.instagram.com/agepbiz
YouTube:
www.youtube.com/user/agepbiz
Twitter:
www.twitter.com/agepbiz
Best regards
Stian
WARNING: CHOKING HAZARD - Small parts
Not for children under 3 yrs.