Thingiverse
Mini 50mm Guttering with attachments. by MalcolmHare1972
by Thingiverse
Last crawled date: 4 years, 7 months ago
** 20/4/2021 - Added inline leaf filter - glue before pipe to drain/butt to prevent leaves/gubbins getting where it shouldnt.
19/4/2021 - Added Hose Attachment piece. - This is so you can attach a piece of hose to the gutter to drain off water into your own container/water butt.
If printed on its side (with support) so the gutter is vertical then the support that partially fills the hose "hole" might as well stay there as a debris blocker.
Rotate the gutters so they stand "tall" and (for the non holed one) you wont need supports
Printed at 3mm and its a good sturdy gutter piece..
The ends & joints will need attaching with a glue gun.
The 45 degree bracket was for screwing under an angled wooden roof... might be of some use to you
Hope this saves you a few quid ! It certainly did me ....
19/4/2021 - Added Hose Attachment piece. - This is so you can attach a piece of hose to the gutter to drain off water into your own container/water butt.
If printed on its side (with support) so the gutter is vertical then the support that partially fills the hose "hole" might as well stay there as a debris blocker.
Rotate the gutters so they stand "tall" and (for the non holed one) you wont need supports
Printed at 3mm and its a good sturdy gutter piece..
The ends & joints will need attaching with a glue gun.
The 45 degree bracket was for screwing under an angled wooden roof... might be of some use to you
Hope this saves you a few quid ! It certainly did me ....