Thingiverse
MillMaster Mill Ozito Drill Mountings by AngryDwarf79
by Thingiverse
Last crawled date: 4 years, 5 months ago
A set of parts for mounting a Millmaster Mill (http://www.mashmaster.com/p/4571858/millmaster-grain-mill.html) to an Oztio 1050w Drill (https://www.bunnings.com.au/ozito-1050w-spade-handle-drill_p6290522)
Side mounts require m10x25 bolts
Rear mount requires m8x25 bolt
10G screws for securing to surface
Spacer between mill and mounting shafts alligns the drive shafts (I'm relatively confident that they're in line enough to not bother with a flexible joint between the drill and mill shaft - but it may be worth it in the long run for the sake of bearings on the mill and drill)
I printed mine in PETG (food safe). But really it shouldn't matter! (That and I had the grey that matched the drill ;))
Make sure to re-orient the pieces to short side flat to print surface (and obviously flat for the spacer) - I can't make fusion360 co-operate on that front for some reason!
Side mounts require m10x25 bolts
Rear mount requires m8x25 bolt
10G screws for securing to surface
Spacer between mill and mounting shafts alligns the drive shafts (I'm relatively confident that they're in line enough to not bother with a flexible joint between the drill and mill shaft - but it may be worth it in the long run for the sake of bearings on the mill and drill)
I printed mine in PETG (food safe). But really it shouldn't matter! (That and I had the grey that matched the drill ;))
Make sure to re-orient the pieces to short side flat to print surface (and obviously flat for the spacer) - I can't make fusion360 co-operate on that front for some reason!