MEYAV1.0 by dugs1212

Last crawled date: 3 years ago

This is a water cooled version of the Yamboo 3d Printer. I print in ABS and run very high temps. The Yamboo is becoming quite the little trooper as I bring it to life.
The build size is 150mm square. I find this to be more than adequate for plastic parts. Especially for ABS. If you have ever tried to print ABS its a nightmare. However the part strength and heat resistance is unmatched. So this machine is destined for a torturous life inside a hot chamber.
1 pc MGN12H 350 mm
2 pcs linear guides 8 mm 270 mm
2 pcs linear guides 8 mm 280 mm
7 pcs linear bearing 8x15x24 mm
1 pc flexible coupling 5 mm to 6 mm
1 piece 6x2 mm screw, length 217 mm
2 pcs pulley G2 16tooth
1 pc belt G2 5 mm width 1,2 m
2 pcs Nema 17 1005
2 pcs Nema 17 1003
1 pc bearing 6x13x5 mm
1 pc spring 7x40 mm
3 pcs switches
1 pc Bowden tube 4x2 mm, 40 cm length
2 pieces of nut up to m3 profile
1 piece profile 30x30 256 mm (bottom)
1 piece profile 30x30 272 mm (upright)
screws m3 and m6 various
nut for profile m6 (insertion ideally)
washers 6,5x18x1,5 mm
MKS Gen. L
REPRAP 12864 Smart Display display graphic
(or TMC2208 2x and A4988 2x drivers
12V or 24V power supply
220mm MK2 Bed 3mm Thick
radial fan 50x10 mm
extruder Bondtech (I used chinese clone)
HotEnd is Water Cooled. "NCR" is etched into it
heated bed 10x10 cm taped from back side to main bed (Must be ABS!)
If you print all the original Yamboo files you will be good to get a PTEG machine.
I can post the water cooled adapter if anyone is interested. Just comment. Its a pain to pull files off Sketchup so let me know.
The Lucky Cat was printed with old crappy ABS filament full of water vapor. I use this to tune with cause its was the closest at hand. LOL. It prints waaaaay better with fresh filament.
I named it the MEYAV1.0. Its a blend of my work and credit to the original maker. "ME" is for me and "YA" for the maker's original Yamboo name. Version 1.0