Thingiverse
Melzi v2.0 Box by URkA
by Thingiverse
Last crawled date: 4 years, 5 months ago
Коробка под Melzi v2.0. Вентилятор 40 мм на 12 вольт. Я использовал черную термо-усадочную трубку,можно взять любую, подходящую. Трубка должна одеваться с некоторым усилием, при закрывании крышки,она автоматически займет нужное положение вокруг светодиода. В крышку вклеил цилиндр из оргстекла,чтобы было видно свечение светодиода на плате. Вентилятор подключил параллельно цепи нагревания стола,чтобы вентилятор не работал,когда принтер не печатает. Можете подключить сразу к источнику питания 12 вольт.
Box under Melzi v2.0. The fan of 40 mm on 12 volts. I used a black thermo-shrinkable tube, it is possible to take any, suitable. The tube has to put on with some effort, when closing a cover, she will automatically reach the necessary position around a light-emitting diode. In a cover I have pasted the cylinder from plexiglas that the light-emitting diode luminescence on a payment was visible. The fan has connected parallel to a chain of heating of a table that the fan didn't work when the printer doesn't print. You can connect to the power supply 12 volts at once.
computer translation
Box under Melzi v2.0. The fan of 40 mm on 12 volts. I used a black thermo-shrinkable tube, it is possible to take any, suitable. The tube has to put on with some effort, when closing a cover, she will automatically reach the necessary position around a light-emitting diode. In a cover I have pasted the cylinder from plexiglas that the light-emitting diode luminescence on a payment was visible. The fan has connected parallel to a chain of heating of a table that the fan didn't work when the printer doesn't print. You can connect to the power supply 12 volts at once.
computer translation