Thingiverse
MaxiMite2 Color Enclosure by uli
by Thingiverse
Last crawled date: 4 years, 11 months ago
This is a enclosure for the awesome MaxiMite 2 Color computer from Geoff Graham (like a C64, Sinclair Spectrum, Schneider CPC computer but way faster and more RAM and a Raspberrry Pi compatible GPIO connector!) with BASIC installed.
Be aware this is for a alternative PCB design, where the STM32 controller is soldered on board (Mainboard V1.5) the original PCB might fit but I'm not sure.
I haven't tested if the NunChuck Controller plug fits into the cutout as I don't have one (yet).
You also need two M3 hex 15mm and two M3 5mm (I used a M3 thread cutter to cut the threads and used alcohol for cooling (just the first few threads, for the rest I used the M3 screws) )
The enclosure was created with FreeCAD version 0.19 Revision 23463
Be aware this is for a alternative PCB design, where the STM32 controller is soldered on board (Mainboard V1.5) the original PCB might fit but I'm not sure.
I haven't tested if the NunChuck Controller plug fits into the cutout as I don't have one (yet).
You also need two M3 hex 15mm and two M3 5mm (I used a M3 thread cutter to cut the threads and used alcohol for cooling (just the first few threads, for the rest I used the M3 screws) )
The enclosure was created with FreeCAD version 0.19 Revision 23463