Thingiverse
MAX 7219 Display Case
by Thingiverse
Last crawled date: 6 years, 6 months ago
Case for a MAX 7219 display, controlled by a ESP 8266 (or ESP 32). Standard plugable USB-connection for power input. Simple wiring via jumper-cables.
Used for displaying data (such as time, weather etc.).
Designed for mounting below a shelf board
(114 mm spacing between the mountings (3, 4)).
Front side is slightly tilted
(for optimal view when sitting on a couch and display is mounted in the livingroom cabinet :-)).
No supports required
(print case and adapter IR frontside facing down).
Lock into position MAX 7219 (9) and the four fixings (5, 8) as well as the magnets (1, 7) with some two-component adhesive.
Adequate software is available in a huge amount in the net.
NOTE: Solder an additional electrolytic capacitor between the plus and minus contacts of the MAX 7219 (see picture) for enhanced voltage stability.
Happy printing !
Used for displaying data (such as time, weather etc.).
Designed for mounting below a shelf board
(114 mm spacing between the mountings (3, 4)).
Front side is slightly tilted
(for optimal view when sitting on a couch and display is mounted in the livingroom cabinet :-)).
No supports required
(print case and adapter IR frontside facing down).
Lock into position MAX 7219 (9) and the four fixings (5, 8) as well as the magnets (1, 7) with some two-component adhesive.
Adequate software is available in a huge amount in the net.
NOTE: Solder an additional electrolytic capacitor between the plus and minus contacts of the MAX 7219 (see picture) for enhanced voltage stability.
Happy printing !