Mavic Pro Spring Loaded Adjustable Tablet / Phone Holder by jmf

Last crawled date: 3 years, 1 month ago

Large and Small size spring loaded adjustable tablet or phone holders for use with the DJI Mavic Pro RC controller.
Two bases with or without a notch if you keep the phone connector installed on the controller.
All you need to complete would be a properly sized 1/4" diameter extension type spring, I bought about a 6" spring and just clipped it to get the amount of tension I wanted.
You'll also need one 1/4 x 20 x 1 1/2 socket head bolt and nut and washer, if you use the knob with the bolt, then insert the bolt into the knob with some medium CA to hold it snug inside the knob.
A couple of small nails will be needed, or in my case I had a couple of small rivets to hold the spring in place, I then trimmed off the ends flush, you can apply a small dab of medium CA on the ends of the pins holding the spring so they don't come out.
The print orientation is the same as the pictures.
I just used .35mm layer and 100% infill for strength, no supports anywhere.