Thingiverse
Master spool (refill) from eono spool by toastfr35
by Thingiverse
Last crawled date: 4 years ago
This is a kit to convert a 'eono' filament spool to a refillable spool.
You'll need to cut the empty spool in 2 halves (following the existing joint) then you can use the bolt and center ring to reassemble it.
2 rings allow to increase the inner diameter of the spool to match 'esun refilament'.
No support needed.
Prints ok at 0.35mm layer with a 0.6mm nozzle
You'll need to cut the empty spool in 2 halves (following the existing joint) then you can use the bolt and center ring to reassemble it.
2 rings allow to increase the inner diameter of the spool to match 'esun refilament'.
No support needed.
Prints ok at 0.35mm layer with a 0.6mm nozzle