Thingiverse
Massive Droner HD Sharkbyte by cadmonkeyfpv
by Thingiverse
Last crawled date: 4 years, 3 months ago
TPU Mounts to utilize the Sharkbyte TX5M.1 on the Catalyst Machineworks Massive Droner HD with the minimortal antenna.
I used a Foxeer Lollipop antenna but since the antenna support is designed to have the cable tied to it any MMCX should work.
VTX is mounted with the RF board facing the stack so that the antenna can pass below the rear cross standoff. Access to the VTX upgrade port is maintained. I mounted the CRSF in a 20mm flex TPU mount by Haku3D on top, with M2 screws through the side cage plate prints and into the VTX.
You'll need 2 copies of the side cage plates with one being mirrored. Press in the bushings provided with the original cage plates, one side of the print has the bushing bore chamfered to make starting the bushing in easier. The antenna mount uses the same mounting as genuine Catalyst parts do on the rear cross standoff and the (2) sheet metal screws through the rear support CF plates.
There are 2 locations to run a cable tie around the VTX antenna but I only utilized the outermost one.
I used a Foxeer Lollipop antenna but since the antenna support is designed to have the cable tied to it any MMCX should work.
VTX is mounted with the RF board facing the stack so that the antenna can pass below the rear cross standoff. Access to the VTX upgrade port is maintained. I mounted the CRSF in a 20mm flex TPU mount by Haku3D on top, with M2 screws through the side cage plate prints and into the VTX.
You'll need 2 copies of the side cage plates with one being mirrored. Press in the bushings provided with the original cage plates, one side of the print has the bushing bore chamfered to make starting the bushing in easier. The antenna mount uses the same mounting as genuine Catalyst parts do on the rear cross standoff and the (2) sheet metal screws through the rear support CF plates.
There are 2 locations to run a cable tie around the VTX antenna but I only utilized the outermost one.