Thingiverse
Marlin 1.1.8 example config for Wanhao Duplicator i3
by Thingiverse
Last crawled date: 5 years, 4 months ago
This version of Marlin requires the 4.7K ohm pull-up version, or that the 10K pull-up resistors have been replaced with standard 4.7K pull-up resistors.
Unzip Marlin-1.1.8 Wanhao config.zip
Bootloader:
Make sure you have the most recent version of AVRDUDE installed
Install Arduino IDE (https://www.arduino.cc/en/Main/Software)
Unzip Gen7.zip to your Arduino hardware library (windows: C:\Program Files (x86)\Arduino\hardware)
Configure an Arduino to act as a FTDI adapter, or buy a dedicated adapter
Flashing process:
1) Open the Arduino IDE
2) Connect the FTDI adapter to the mainboard
3) connect the mini USB cable to a power source (PC or powerbank)
4) Remove boot jumper and press reset. Reinstall boot jumper. Board is now in bootloader mode.
5) Upload firmware using Arduino.
Unzip Marlin-1.1.8 Wanhao config.zip
Bootloader:
Make sure you have the most recent version of AVRDUDE installed
Install Arduino IDE (https://www.arduino.cc/en/Main/Software)
Unzip Gen7.zip to your Arduino hardware library (windows: C:\Program Files (x86)\Arduino\hardware)
Configure an Arduino to act as a FTDI adapter, or buy a dedicated adapter
Flashing process:
1) Open the Arduino IDE
2) Connect the FTDI adapter to the mainboard
3) connect the mini USB cable to a power source (PC or powerbank)
4) Remove boot jumper and press reset. Reinstall boot jumper. Board is now in bootloader mode.
5) Upload firmware using Arduino.