Thingiverse
Malt Mill mount and box by Naesstrom
by Thingiverse
Last crawled date: 4 years, 8 months ago
Mount for a windshield wiper motor and box for electronics.
Distance from bottom to center of motor pin is 68mm so you might need to adjust it to your grain mill.
c/c on the holes of the motor is 40mm
Here are links for the parts
Motor: https://www.skruvat.se/show.aspx?k=17363
Coupler:https://banggood.app.link/fuxLbYwZAeb (10mmx12mm)
Then you can source the following wherever:
m6 extension nut (m6x30) where you file half of it round to fit in the coupler
XT60 connector between box and motor
Circular power switch 20mm diameter (or larger if you want to drill)
dc powerjack (https://banggood.app.link/gM6wD2KAEeb)
3x m6x30 (fasten motor to mount)
2x zipties (fasten box to motor)
5x woodscrews (fasten mount to millplate)
Distance from bottom to center of motor pin is 68mm so you might need to adjust it to your grain mill.
c/c on the holes of the motor is 40mm
Here are links for the parts
Motor: https://www.skruvat.se/show.aspx?k=17363
Coupler:https://banggood.app.link/fuxLbYwZAeb (10mmx12mm)
Then you can source the following wherever:
m6 extension nut (m6x30) where you file half of it round to fit in the coupler
XT60 connector between box and motor
Circular power switch 20mm diameter (or larger if you want to drill)
dc powerjack (https://banggood.app.link/gM6wD2KAEeb)
3x m6x30 (fasten motor to mount)
2x zipties (fasten box to motor)
5x woodscrews (fasten mount to millplate)