MakerGear M2 rear cable harness guide by TimEdwards

Last crawled date: 4 years, 6 months ago

I used to have the cable harness on my M2 cable-tied to the outside of the printer's frame on the right side. However, when I installed the dual extruder upgrade, I quickly discovered that the wire harness interfered with the filament spools, which were also on the right side. So I moved the wire harness to the inside of the frame. There, though, it has barely enough room and brushes up against the heated bed bracket. So I designed a channel for the cable harness that puts the cables behind and in line with the frame, where they are not in the way of either the Z-stage assembly or filament spools on the right side. And it keeps things neat and tidy.