Thingiverse
MakeHackVoid Toilet Roll Holder by devdsp
by Thingiverse
Last crawled date: 4 years, 7 months ago
The sprung plastic part of the toilet roll holder was broken so I pulled the spring out designed this part and printed it off on our rostock.
Designed to fit a120mm span. The spring is 20mm x 60mm.
If I was going to print it again I'd combine the long shaft with one of the pegs but it works fine as is.
Designed to fit a120mm span. The spring is 20mm x 60mm.
If I was going to print it again I'd combine the long shaft with one of the pegs but it works fine as is.