MACSBOOST Davinci E3D V6 Uberstruder mount. by macsboost

Last crawled date: 3 years ago

This is my fourth iteration of an adapter to allow use of an E3d V6 on a davinci 1.0A
Lots of effort went into making this work with minimal mods. The stepper motor assembly does get moved up 31mm, the width of the stepper bolt pattern and using the original holes. Once moved up, this adapter allows use of the stock direct drive hardware, spring clip, fan and parts. Care was taken to fit snugly into the carriage to reduce slop. Nozzle height is very close to the stock height and should not require further modification. A small piece of teflon tubing about 1.5" is recommended to insert into the mount and heatsink as seen in the pictures. It is tight, but with the motor now higher is much easier to install the extruder. You will likely want to cut about 1/2" off the top of the extruder filament inlet tube.