Thingiverse
macintosh 6, 7 and 8 by hugoarchicad
by Thingiverse
Last crawled date: 4 years, 6 months ago
Hi!
As you might know by now i love apple.
Specially the macintosh.
One day i will buy an old one, but here in Australia they are hard to come by.
So in the meantime i have created a macintosh inspired Iphone 8 holder.
No support needed.
the front bit (that holds the phone) is meant to print on its side with no support (and the end bit (where the end stops the phone from sliding any further is meant to be the base)
the other part (box) is meant to be printed on its back with no support.
I ended up printing 3 different fronts until the fit was good , not too tight and not loose.
This is the best i have found.
enjoy
As you might know by now i love apple.
Specially the macintosh.
One day i will buy an old one, but here in Australia they are hard to come by.
So in the meantime i have created a macintosh inspired Iphone 8 holder.
No support needed.
the front bit (that holds the phone) is meant to print on its side with no support (and the end bit (where the end stops the phone from sliding any further is meant to be the base)
the other part (box) is meant to be printed on its back with no support.
I ended up printing 3 different fronts until the fit was good , not too tight and not loose.
This is the best i have found.
enjoy