Thingiverse
Macbook Stand by eFinity
by Thingiverse
Last crawled date: 4 years, 3 months ago
I designed this stand to fit a Early 2015 13' Macbook, not sure if it'll fit the other Macbooks. If you want to measure to see if it'll fit your Macbook, the laptop slot is 18.75mm wide. When finish printing using PLA, it shrunk to about 18.70mm for me and it was still perfect fit.
I made some careful measurements for the laptop slot as I didn't want it so tight that the keyboard will imprint onto the LCD screen which will scratch the anti-glare coating. I also made two 2mm slots at the base to vent out heat when using it in clamshell mode. If you plan on using rubber feet, this wouldn't matter much.
I made some careful measurements for the laptop slot as I didn't want it so tight that the keyboard will imprint onto the LCD screen which will scratch the anti-glare coating. I also made two 2mm slots at the base to vent out heat when using it in clamshell mode. If you plan on using rubber feet, this wouldn't matter much.