Luzbot Taz 6 chassis filter holder *version 2* by jlee1026 3d model
3dmdb logo
Thingiverse
Luzbot Taz 6 chassis filter holder *version 2* by jlee1026

Luzbot Taz 6 chassis filter holder *version 2* by jlee1026

by Thingiverse
Last crawled date: 4 years, 1 month ago
This is an updated version of https://www.thingiverse.com/thing:1928305. Matches slit cut outs of the chassis. Should provide better air flow.
Print, cut a piece of dust wipe (Swifer used in photo), insert filter into the grid and install the filter holder. Help reduce the amount of "stuff" that your Taz collects over time.
Filter media: dust wipe (Swifer used in photo), cut to approx. 85mm x 50mm
Filter holder Installation: Insert side with large clip into the center slot of the vent, then swing the grid up and clip in to the two larger slots at the top.
Removal: Gently press down on the two finger tabs and swing down and un-clip the filter holder from chassis.

Tags