Lulzbot Mini UDOO Mounting Bracket by TheKre8Group

Last crawled date: 3 years, 1 month ago

Little bracket to mount a UDOO (this is a Quad) on the side of the Lulzbot Mini.
// I use the UDOO to run OctoPrint
Required:
5x Nylon M3x9 screws
8x Nylon M3 nuts
M3 Tapping tool
Instructions:
1- Tap all 4 holes (the center one doesn't need it)
2- Screw bracket on with a M3 nylon screw to the M3 hole on the side of the printer (mine had a screw missing, i'm not sure if it's supposed to be that way, but in any case remove the screw if needed - it just holds the PSU in place)
3- place 4 screws in the UDOO, at the right place and screw on 2 nuts, not too tight to prevent the screw from turning. (these act as spacers)
4- screw the 4 screws to the bracket, the PSU Connector should face the back of the printer.