Thingiverse
Lulzbot Mini Filament Guide by dave312
by Thingiverse
Last crawled date: 4 years, 2 months ago
With the far right placement of the filament spool on the mini you can end up with the filament getting pulled to some pretty extreme angles with respect to the hobbed bolt assembly. I found I was ending up with the occasional jam or skip due to this angle change, so I designed this part to help guide the filament straight into the bolt.
The part is designed to fit snugly into the little slots just above the bearing assembly. You'll need to sand or adjust dimensions slightly depending on your filament because you want a nice tight fit. I'd also recommend something like ABS or PETG for stiffness.
No supports required if you print it oriented as shown.
The part is designed to fit snugly into the little slots just above the bearing assembly. You'll need to sand or adjust dimensions slightly depending on your filament because you want a nice tight fit. I'd also recommend something like ABS or PETG for stiffness.
No supports required if you print it oriented as shown.