Lulik - RC stunt car. 3d model
3dmdb logo
Thingiverse
Lulik - RC stunt car.

Lulik - RC stunt car.

by Thingiverse
Last crawled date: 4 years, 2 months ago
pleas note, I updated 4 new files:
the top plate, its bigger with additional 2 holes.
one of the gear (43t instead of 42t).
smaller wheel (130mm instead of 150mm).
thick side support(5mm instead of 2mm).
All due to experience while driving.
** assembly vid: https://youtu.be/GL2jyfFSpVI .
That is the best RC car i know that is 3D printed, very durable, very fast, it can flip so it is never stops. Lots of fun.
I build many RC cars and this is my master piece, i put all of my knowledge and experience in this one.
The main features are:
High durability.
All parts, except shafts and electronics are 3D printed.
Fast.
Can flip and roll over.
Have "regular steering" which is not very common in RC stunt cars.
Easy to maintain.
Low cost parts.
Quite easy to assemble, although you do need to have good hands. (makers will do good)
Easy to print files.
See it in this video:https://www.youtube.com/watch?v=zzvEAxoDoII
what you will need for this:
2X 32dp 12t gears (metal ones - about 3USD on the web).
2X A2212 1000KV brushless motors.
2X 25-60A ESC for brushless motors.
1X 2s LiPo battery.
2X 3/8" threaded rod, 195mm long as main wheels shafts.
2X M4x52 thread piece (can be cutted from M4x60mm screw).
1X mg996 servo
Lot of screws ISO-7049 d2.9x10mm
12X 15x10x3mm bearings .
If I will remember anything else I will update later.
Printed mainly in PLA.
Red parts printed with PLAFLEX (like TPU).
No supports are needed. very easy to print files.

Tags