Lorei spool holder by tuxcat

Last crawled date: 3 years, 1 month ago

spool holder for XMachines Lorei printer. Attaches to the back of the printer using the two cover plate screws. Insert a piece of 1/2" PVC tubing cut to your desired length.
I added a taller version for holding larger spools that is also flush with the edge of the printer, and an end cap to keep the spools from riding off the end of the PVC.
The taller version is too flimsy for large spools. I made a new version (rev 6) that is designed to be used with some 1/2" PVC. Nice and sturdy and can hold two large spools without issue. I put a hole in the front for a screw to hold the PVC in place, but the fit was so tight, I didn't need it.
parts needed for rev 6:
1 - 5" x 1/2" PVC (cut one end at about a 30 degree angle to fit to the bottom of the base
2 - 4" x 1/2" PVC
1 - 1/2" TEE PVC
1 - printed rev 6 base
2 - printed end caps