Thingiverse
Left handed duplicator 6 blower cooling duct with probe mount by frederikkemner
by Thingiverse
Last crawled date: 4 years, 7 months ago
Added 1bigpig's 12mm probe mount. It's offset 5mm more to the right, so make sure you are using the following lines in the firmware config instead of the ones provided:#define X_PROBE_OFFSET_FROM_EXTRUDER 40 // X offset: -left +right [of the nozzle]#define Y_PROBE_OFFSET_FROM_EXTRUDER -16 // Y offset: -front +behind [the nozzle]
I also improved printability. The nozzles are now connected to the main part from the first layer on so they don't come off during printing anymore. I also cut off 0.2mm from the bottom of the part to increase the surface area of the circular part. Lastly I added a helper disc, that you can simply cut off, which will prevent the circular part from lifting off during the first few layers.
You need supports for the probe mount. I also added manual supports in my Slicer close to where the fan mounts inside of the circular part where the roof is horizontal. Make sure you don't add too much or it will be a pain to remove.
I also improved printability. The nozzles are now connected to the main part from the first layer on so they don't come off during printing anymore. I also cut off 0.2mm from the bottom of the part to increase the surface area of the circular part. Lastly I added a helper disc, that you can simply cut off, which will prevent the circular part from lifting off during the first few layers.
You need supports for the probe mount. I also added manual supports in my Slicer close to where the fan mounts inside of the circular part where the roof is horizontal. Make sure you don't add too much or it will be a pain to remove.