Thingiverse
Led ramp for Anychubic Mega by Mapessional
by Thingiverse
Last crawled date: 4 years, 5 months ago
Hi,
I designed led lighting for Anycubic Mega. It is necessary to print two holders which are screwed on top of the printer using four M3 screws. Next, print 4 corner pieces.
I used the R5 profile as shown in the picture to fasten the LED strip.
The hole in the holder is for the power cable. You can choose whether to bring the cable from the right or left side.
I printed from PLA.
Please leave a comment or question.
Bye
I designed led lighting for Anycubic Mega. It is necessary to print two holders which are screwed on top of the printer using four M3 screws. Next, print 4 corner pieces.
I used the R5 profile as shown in the picture to fasten the LED strip.
The hole in the holder is for the power cable. You can choose whether to bring the cable from the right or left side.
I printed from PLA.
Please leave a comment or question.
Bye