Thingiverse
Leaky Pipe diverter
by Thingiverse
Last crawled date: 5 years, 10 months ago
A leaky joint on water pipe was soaking every thing.
This diverter collects the water and diverts it into a waiting container.
Print the with wide end flat on the bed (upside down).
Printed fine at 0.16mm layer height printed on my Ender 5 without supports.
Might need supports with a thicker layer height.
Update v2
Added two new versions that will seal better and should work better.
This diverter collects the water and diverts it into a waiting container.
Print the with wide end flat on the bed (upside down).
Printed fine at 0.16mm layer height printed on my Ender 5 without supports.
Might need supports with a thicker layer height.
Update v2
Added two new versions that will seal better and should work better.