LD-002R - Rear Fan Mount Vent / Ducting by Pheelix14

Last crawled date: 3 years, 3 months ago

Update 1-13-2021
Added Magnet Mounted versions. Magnets
I wanted to exhaust the Resin smell the best I could outside. So I made this Mount for the back of the LD-002R that holds a fan. I used 3" tubing to go from the printer to the window. I attached a 120mm fan to the dryer exhaust (the 3 flap type) for extra air flow.
The fan attached to the base that is mounted to the printer is wired to the same stock exhaust fan on the inside of the printer. This way it will only turn on when you start printing. The 120mm fan on the dryer exhaust is hooked up to a custom made switch/power adapter.
I use a GPU fan from Zantec, but I made base/mounts for 70-80mm fans. If you plan to use 4" tubing, I made a mount to go on the base for that size as well.
I mounted the base using the screw that was already on the bottom back part of the printer, and then drilled and tapped a hole for the top. Make sure to remove the back part of the printer if you wish to do the same. This can be done by removing the 1 screw at the back/bottom and the 2 on each side by the back of the printer. The panel should slide back and out.
I will post pictures of what it looks like on the printer later.