Thingiverse
Laser air assist nozzle, fits K40 China laser by zilvertail
by Thingiverse
Last crawled date: 4 years, 3 months ago
You'll need this print and one Pneumatic 12mm-1/4" BSPT male fitting
I printed with to shells just incase.
Finish printing and while still hot heat up a fitting of size 12mm-1/4" BSPT
Once the fitting is hot it should screw right on. The first i printed was a little to tight so i lite it up quickly and attached a preheated fitting.
Seal it and attach as you see fit, FIY. Some casket sealing and some cable ties might give you a perfect fit, further more this have a hole for a set screw near the top.
I printed with to shells just incase.
Finish printing and while still hot heat up a fitting of size 12mm-1/4" BSPT
Once the fitting is hot it should screw right on. The first i printed was a little to tight so i lite it up quickly and attached a preheated fitting.
Seal it and attach as you see fit, FIY. Some casket sealing and some cable ties might give you a perfect fit, further more this have a hole for a set screw near the top.