Thingiverse
Large Multisensor Enclosure by mk717
by Thingiverse
Last crawled date: 4 years, 5 months ago
Multisensor enclosure inspired by BRUH. Wanted something a little bigger to allow plenty of room for wiring and possibly adding other sensors.
I put a small dab of hot glue on the nodemcu standoffs to keep it in place. Screws were just too much of a pain. I opted to mount the nodemcu on the side for (I think) easier cable management.
DHT22 mount/cover remixed from http://www.thingiverse.com/thing:480481
DHT22 can be screwed down but the fit is pretty snug and will snap in.
Lid is also just pressure fit. Small slot in the back to pry open.
I put a small dab of hot glue on the nodemcu standoffs to keep it in place. Screws were just too much of a pain. I opted to mount the nodemcu on the side for (I think) easier cable management.
DHT22 mount/cover remixed from http://www.thingiverse.com/thing:480481
DHT22 can be screwed down but the fit is pretty snug and will snap in.
Lid is also just pressure fit. Small slot in the back to pry open.