Thingiverse
Lapsync Timing Gate Parts by NorCAL3D
by Thingiverse
Last crawled date: 4 years, 7 months ago
Here is a couple parts I revised for the timing gate. This gate works great, these are just some minor revisions to improve fit and finish.
The End Plug with Tab.stl is a revised version of the spacer rings. This one includes a tab that replaces part of the slot we cut out of the PVC. When the PVC is slid into the Connectors, you get some slop due to the lack of material on one face. This tightens it up.
The Trackmate Pickup Mount.stl is a revision to reduce the amount of material used and add a couple holes for the trackmate pickup to screw into. Fits 3mm screws.
Wireless Module 3s4000 Zippy Mount.stl is a clamp to hold the Wireless Module and a 3s4000 Zippy battery on the timing stand. The battery slot measures ~22x43mm. And should fit a wide selection of 3s3300-5000 packs. There is a recessed hole for a 3mm bolt and the other side has a slot for a 3mm nut (non-nylock).
The End Plug with Tab.stl is a revised version of the spacer rings. This one includes a tab that replaces part of the slot we cut out of the PVC. When the PVC is slid into the Connectors, you get some slop due to the lack of material on one face. This tightens it up.
The Trackmate Pickup Mount.stl is a revision to reduce the amount of material used and add a couple holes for the trackmate pickup to screw into. Fits 3mm screws.
Wireless Module 3s4000 Zippy Mount.stl is a clamp to hold the Wireless Module and a 3s4000 Zippy battery on the timing stand. The battery slot measures ~22x43mm. And should fit a wide selection of 3s3300-5000 packs. There is a recessed hole for a 3mm bolt and the other side has a slot for a 3mm nut (non-nylock).