Thingiverse
KTM Custom Mount for Trailtech Vapor by nikollou
by Thingiverse
Last crawled date: 4 years, 3 months ago
I have a KTM EXC 200 2003 model and wanted to be able to mount my Traitech Vapor while maintaining the cushion that goes over the handlebar.
I do not know with confidence which other models this will fit but an educated guess is that it will work with other EXC's (like the 125) and the SX models of the same generation too. Try it out and let us know in the comments if you got it to work on your bike!
This mount attaches to the bottom of the steering column and is designed so the Trailtech is positioned just below the front fairing.
I wanted it to be hidden for a few reasons:
to protect the device
to keep the functionality of the cushion (which is to protect you from banging on something hard in front of you)
to keep it discrete.
The shroud is loosely based on ddoto's cover but obviously it has been re purposed, I have changed the dimensions a bit and created the necessary holes at the back. The stem screws onto the lower steering column and then protrudes up just enough for the shroud to be mounted while keeping the vapor unit below the cushion.
I created it as two separate parts first of all to make them easier to print and secondly because I think the stem will be more likely to fail in which case you can re-print it and keep the shroud.
Both parts can be printed with no support.
I do not know with confidence which other models this will fit but an educated guess is that it will work with other EXC's (like the 125) and the SX models of the same generation too. Try it out and let us know in the comments if you got it to work on your bike!
This mount attaches to the bottom of the steering column and is designed so the Trailtech is positioned just below the front fairing.
I wanted it to be hidden for a few reasons:
to protect the device
to keep the functionality of the cushion (which is to protect you from banging on something hard in front of you)
to keep it discrete.
The shroud is loosely based on ddoto's cover but obviously it has been re purposed, I have changed the dimensions a bit and created the necessary holes at the back. The stem screws onto the lower steering column and then protrudes up just enough for the shroud to be mounted while keeping the vapor unit below the cushion.
I created it as two separate parts first of all to make them easier to print and secondly because I think the stem will be more likely to fail in which case you can re-print it and keep the shroud.
Both parts can be printed with no support.