Thingiverse
Ktm 390 Adventure windshield elevator by Reifircax
by Thingiverse
Last crawled date: 4 years, 9 months ago
This piece purpose is to straighten the windshield on a KTM 390 Adventure by 15°.
I put a Puig windshield (which is really higher than the stock one) and with the stock angle as high was it, it were not protective enough
You will need a M5 threaded insert to attach the windshield
You can print it on the side with support but not for the holes, so, you can set a overhang angle at 88°
I put a Puig windshield (which is really higher than the stock one) and with the stock angle as high was it, it were not protective enough
You will need a M5 threaded insert to attach the windshield
You can print it on the side with support but not for the holes, so, you can set a overhang angle at 88°