kossel??????? by wangrui19890704

...thingiverse inspired by the frame extension of the anycubic kossel linear, i developed an easy to print corner brace....

...x 11mm x 6.35mm regular spacers three (3) mini kossel 5mm x 21.5mm x 7mm wheels m6 x 12mm...

...dware savvy type. adding up cost of fsr sensors, time to solder, and nano the ~30 bucks plus shipping is a good deal for a kit.

...board. in my case, i developed a simple rack that puts the board within range of all but one end-stop, which was simple to tweak.

...bs against the tensioning knobs, so lengthened it another 25mm and this let me shift the spool towards the centre of the frame...

...ad hotend link here: https://rb.gy/inq8w9 3d filament 1.75mm color: red--->used in this print build<---https://rb.gy/0syrgd

...finds this as useful as i did. my print bed is 220mm round, but it should work for any size of kossel that uses 2020 extrusions.

...ogo down, the cable holder can be printed however you deem right. the cable canal is alittle small, but could not make it bigger.

...better version of "carriage with belt tensioner for anycubic kossel plus" by alezsx. what i've done: as you can...

...s still under the test you need to set 2800 steps per mm for the first iteration and then make calibration of extruder for sure.