Thingiverse
Kindle Paperwhite 2/3 Case by TurboGLH
by Thingiverse
Last crawled date: 4 years, 7 months ago
v2 has fixed radius on the pocket, older version had a mistake that caused some slight warping when fully seated.
STEP Files Included
Full back Kindle Paperwhite 2/3 Case I made for my wifes project. None of the existing ones had model files, and it was also difficult to remove the kindle from the case without significant force/twisting.
Has three retaining points vs four, and large radiuses on either side of the top one, allowing for easy removal.
Supports are needed for the two lower retaining points, and I've had some slight curling/drooping of the upper, only slight cleanup is needed.
Printed at both 0.1 and 0.2 layer height, finish is excellent at 0.1, but we've been using 0.2 to simulate the look of stacked paper.
STEP Files Included
Full back Kindle Paperwhite 2/3 Case I made for my wifes project. None of the existing ones had model files, and it was also difficult to remove the kindle from the case without significant force/twisting.
Has three retaining points vs four, and large radiuses on either side of the top one, allowing for easy removal.
Supports are needed for the two lower retaining points, and I've had some slight curling/drooping of the upper, only slight cleanup is needed.
Printed at both 0.1 and 0.2 layer height, finish is excellent at 0.1, but we've been using 0.2 to simulate the look of stacked paper.